Previous Entry Share Next Entry
i2c IO Expander
tibman wrote in arduino_related

Need more digital IO ports?

Another i2c post. This one is about a 16 port IO Expander that works well with the arduino. I'm driving a bunch of leds with it now, i guess you could get eight of these things and drive 128 leds through i2c if you wanted.

Part Description: IC I/O Expander I2C 16B 28SDIP
Digikey part number: MCP23016-I/SP-ND
Price from Digikey: $1.90 US on 20 Sep 09

You will also need two additional parts to support the chip.
1x 33pF Cap
1x 3.9k Resistor

Wiring Diagram

Once the chip is setup, it's very easy to use. The device's i2c address is 0100xxx. Connecting an addr pin to ground makes it '0' and to +5v makes it '1'. This gives you enough addresses to use eight expanders at the same time. Also, this device didn't like i2c bus speed over 100k :(

I ended up writing a library (class) to manage the IO expander. It's kind of big so i'm just going to put the important bits here.

//Basic Write command
void Write(byte reg, byte data1, byte data2)
  Wire.send(reg); // Command

//Read inputs
void Read()
  //Set read from GP0
  Wire.send(0x00); // Command: Access to GP0
  //Recieve bytes from module
  Wire.requestFrom(addr,2); //only two bytes
  { io_data[0].set(Wire.receive()); io_data[1].set(Wire.receive());}
  else {Serial.println("ERROR: request from GP0 failed");} //FIXME - this should be removed

The Datasheet has a list of commands. The important ones are 0x06 (io direction) and 0x00 (pin status). All reads and writes have to be done in pairs. So even if you only want to read one pin, you have to read two bytes (16 bits) and extract the one you want.

I had a difficult time doing bitwise stuff (my first time really) and made a debug function to help. If you are having problems i recommend something like this, it helps so much.

I think it's a great little chip. If you ever feel like your arduino is running out of IO space, drop $2 into one of these. Well worth it!

Two leds and a Button hooked up to the IO Expander

  • 1
I'm flying a white flag...I can't even figure out if my problem is wiring, software, or both. I just ordered a Centipede Shield with connectors....$25 shipped; I should have just done it from the start.

No problem man. I looked at your code and the address you are using (27) is B00011011. I'm not at a computer with the arduino ide installed but i think you need to put the B symbol before your binary. (byte out1 = 00000001) != (byte out1 = B00000001)

If you can link the datasheet for your chip, i can help you get it wired up. The hardware part is the difficult part for me, to be honest. But if your hardware is right, a few changes in software should get your IO expander working perfectly.

Going with a pre-made shield is definitely the easiest way to learn, imo. I could not find any shields like that mid-2009 so i had to find something simple and stumbled onto these cheap i2c chips. Once you get one i2c chip working, it'll open up more fun stuff like EEPROM, RTC, RAM, and Crypto. I hope you can get something working for you.

Instead of Wire.beginTransmission(27), try Wire.beginTransmission(71) or Wire.beginTransmission(B01000111);

  • 1

Log in

No account? Create an account